Standard

ASTM B655/B655M - 10(2018) en

Standard Specification for Niobium-Hafnium Alloy Bar and Wire

44,68 54,06 Incl BTW

About norm

Status Current
Number of pages 4
Published on 01-10-2018
Language English

1.1 This specification covers hafnium alloyed niobium bar and wire.

1.2 The material covered by this specification is R04295, niobium-base alloy containing approximately 10 % hafnium and 1 % titanium.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4 The following safety hazards caveat pertains only to the test methods portion, Section 14, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Details

ICS-code 77.150.99
English title Standard Specification for Niobium-Hafnium Alloy Bar and Wire
Replaces

Shopping Basket

Subtotal:

Go to shopping basket