Standard

ASTM C42/C42M - 16 en

Standard Test Method for Obtaining and Testing Drilled Cores and Sawed Beams of Concrete

  • This norm is withdrawn since 15-03-2018

50,60 61,23 Incl BTW

About norm

Status Withdrawn
Number of pages 7
Published on 01-10-2016
Language English

1.1 This test method covers obtaining, preparing, and testing cores drilled from concrete for length or compressive strength or splitting tensile strength determinations. This test method is not applicable to cores from shotcrete.

Note 1: Test Method C1604/C1604M is applicable for obtaining, preparing, and testing cores from shotcrete.

Note 2: Appendix X1 provides recommendations for obtaining and testing sawed beams for flexural performance.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 The text of this standard references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.

1.4 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 91.100.30
English title Standard Test Method for Obtaining and Testing Drilled Cores and Sawed Beams of Concrete
Replaces
Replaced by

Shopping Basket

Subtotal:

Go to shopping basket