Standard

ASTM D1675 - 18 en

Standard Test Methods for Polytetrafluoroethylene Tubing

50,27 60,83 Incl BTW

About norm

Status Current
Number of pages 6
Published on 01-05-2018
Language English

1.1 These test methods cover procedures for testing polytetrafluoroethylene tubing for use as electrical insulation. The procedures appear in the following sections:


  Procedure


Sections

  ASTM
  Methods

 

 

 

Conditioning

7

...

Dielectric Breakdown Voltage

28 – 30

D149, D876

Inside Diameter

8 – 13

D876

Mandrel Bend Test

46 – 52

D149, D876

Melting Point

41 – 45

D3418, D4895

Penetration Test

26 and 27

D876

Specific Gravity

36 – 40

D792, D1505

Strain Relief

31 – 35

...

Volatile Loss

20 – 25

...

Wall Thickness

14 – 19

...

Note 1: These test methods are similar but not identical to those in IEC 60684–2.

1.2 The values stated in inch-pound units are the standard except for temperature, which is stated in degrees Celsius. Values in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific warning statements, see Section 5.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Details

ICS-code 29.035.20
Dutch title Standard Test Methods for Polytetrafluoroethylene Tubing
English title Standard Test Methods for Polytetrafluoroethylene Tubing
Replaces

Shopping Basket

Subtotal:

Go to shopping basket