Standard

ASTM D2609 - 02(2008) en

Standard Specification for Plastic Insert Fittings for Polyethylene (PE) Plastic Pipe

  • This norm is withdrawn since 01-12-2014

50,24 54,76 Incl BTW

About norm

Status Withdrawn
Number of pages 4
Published on 01-11-2008
Language English

1.1 This specification covers plastic insert fittings for polyethylene (PE) plastic pipe. Included are requirements for materials, workmanship, dimensions, and burst pressure.

1.2 The text of this specification references notes, footnotes, and appendixes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the specification.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 The following safety hazards caveat pertains only to the test methods portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 23.040.45
English title Standard Specification for Plastic Insert Fittings for Polyethylene (PE) Plastic Pipe
Replaced by

Shopping Basket

Subtotal:

Go to shopping basket