Standard

ASTM D3121 - 17 en

Standard Test Method for Tack of Pressure-Sensitive Adhesives by Rolling Ball

44,68 54,06 Incl BTW

About norm

Status Current
Number of pages 3
Published on 01-05-2017
Language English

1.1 This test method covers measurement of the comparative tack of pressure-sensitive adhesives by a rolling ball and is most appropriate for low-tack adhesives. This test method is only one of several available for the measurement of tack.

1.1.1 This test method is not recommended for the specification of end use products.

1.2 Values stated in either SI or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents, therefore, each system must be used independently without combining values in any way.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Details

ICS-code 83.180
English title Standard Test Method for Tack of Pressure-Sensitive Adhesives by Rolling Ball
Replaces

Shopping Basket

Subtotal:

Go to shopping basket