Standard

ASTM D5227 - 01(2008)e1 en

Standard Test Method for Measurement of Hexane Extractable Content of Polyolefins

  • This norm is withdrawn since 01-06-2013

50,24 54,76 Incl BTW

About norm

Status Withdrawn
Number of pages 4
Published on 01-11-2008
Language English

1.1 This test method describes an extraction/gravimetric procedure for determination of the amount of hexane soluble low molecular weight material present in polyethylene, polypropylene, ethylene-propylene copolymers, and ethylene-vinyl acetate copolymers. This test method is a modification of the Food and Drug Administration (FDA) procedure for determining hexane extractables of polyolefins. This test method is based upon the presumption that the weight of the residue extract present in the solvent is equal to the amount extracted from the film sample and could therefore be quantified by measuring the weight loss of the extracted film, eliminating the complex and time-consuming evaporation process described in 21 CFR 177.1520.

1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.3 The values stated in SI units are to be regarded as the standard. Units used in 21 CFR 177.1520 are also used in this test method. Units are in conformance with Federal Code 21 CFR 177.1520, from which this test method is derived.

Note 1—There is no known ISO equivalent ISO to this test method.

Details

ICS-code 83.080.20
English title Standard Test Method for Measurement of Hexane Extractable Content of Polyolefins
Replaced by

Shopping Basket

Subtotal:

Go to shopping basket