Standard

ASTM D7293 - 06 en

Standard Test Method for Extruded and Compression-Molded Shapes Made from Polyetherimide (PEI)

  • This norm is withdrawn since 01-08-2012

50,27 60,83 Incl BTW

About norm

Status Withdrawn
Number of pages 5
Published on 01-12-2006
Language English

1.1 This test method covers requirements and test methods for the material, dimensions, and workmanship, and the properties of extruded and compression-molded sheet, plate, rod and tubular bar manufactured from polyetherimide (PEI) resins.

1.2 The properties included in this test method are those required for the compositions covered. It is possible that other requirements will be necessary to identify particular characteristics important to specialized applications. These shall be agreed upon between the user and the supplier, by using the suffixes as given in Section 5.

1.3 This test method does not allow for the use of recycled plastics (as defined in Guide D 5033).

1.4 The values stated in inch-pound units are regarded as standard in all property and dimensional tables. For reference purposes, SI units are also included in Table 1 and Table S-PEI.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1

There is no similar or equivalent ISO standard.

Details

ICS-code 83.080.20
English title Standard Test Method for Extruded and Compression-Molded Shapes Made from Polyetherimide (PEI)
Replaced by

Shopping Basket

Subtotal:

Go to shopping basket