Standard

ASTM D731 - 18 en

Standard Test Method for Molding Index of Thermosetting Molding Powder

50,24 54,76 Incl BTW

About norm

Status Current
Number of pages 4
Published on 01-05-2018
Language English

1.1 This test method covers the measurement of the molding index (plasticity) of thermosetting plastics ranging in flow from soft to stiff by selection of appropriate molding pressures within the range from 3.7 to 36.5 MPa (530 to 5300 psi).

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Details

ICS-code 83.080.10
Dutch title Standard Test Method for Molding Index of Thermosetting Molding Powder
English title Standard Test Method for Molding Index of Thermosetting Molding Powder
Replaces

Shopping Basket

Subtotal:

Go to shopping basket