Standard

NEN-EN 10270-3:2001 en

Steel wire for mechanical springs - Part 3: Stainless spring steel wire

  • This norm is withdrawn since 04-11-2011

50,04 60,55 Incl BTW

About norm

Status Withdrawn
Number of pages 22
Committee Staal – overige toepassingen
Published on 01-05-2001
Language English
This Part of EN 10270 applies to the grades of stainless steels listed in Table 1, which are usually used in the cold drawn condition in the form of wire of circular cross-section up to 10,00 mm in diameter, for the production of springs and spring parts that are exposed to corrosive effects and sometimes to slightly increased temperatures (see A.1). 1.2 In addition to the steels listed in Table 1 certain of the steel grades covered by EN 10088-3 e.g.1.4571, 1.4539, 1.4028 are also used for springs, although to much lesser extent. In these cases the mechanical properties (tensile strength, etc.) should be agreed between purchaser and supplier. Similarly, diameters between 10,00 mm and 15,00 mm may be ordered against this standard; in this case the parties should agree upon the required mechanical characteristics. 1.3 In addition to this part of EN 10270 the general technical delivery requirements of EN 10021 are applicable.

Details

ICS-code 77.140.25
77.140.65
Dutch title Staaldraad voor mechanische veren - Deel 3: Corrosievast verenstaaldraad
English title Steel wire for mechanical springs - Part 3: Stainless spring steel wire
Replaces
Replaced in future

Shopping Basket

Subtotal:

Go to shopping basket