Standard

NEN-EN-IEC 62196-2:2017 en

Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 2: Dimensional compatibility and interchangeability requirements for a.c. pin and contact-tube accessories

311,27 339,28 Incl BTW

About norm

Status Current
Number of pages 122
Published on 01-05-2017
Language English
NEN-EN-IEC 62196-2 applies to plugs, socket-outlets, vehicle connectors and vehicle inlets with pins and contact-tubes of standardized configurations, herein referred to as accessories. They have a nominal rated operating voltage not exceeding 480 V a.c., 50 Hz to 60 Hz, and a rated current not exceeding 63 A three-phase or 70 A single phase, for use in conductive charging of electric vehicles. This part of IEC 62196 covers the basic interface accessories for vehicle supply as specified in IEC 62196-1, and intended for use in conductive charging systems for circuits specified in IEC 61851-1:2010. These accessories are intended to be used for circuits specified in IEC 61851-1:2010 which operate at different voltages and frequencies and which may include extra-low voltage (ELV) and communication signals. These accessories may be used for bidirectional power transfer (under consideration). This standard applies to accessories to be used in an ambient temperature between -30 °C and +50 °C. These accessories are intended to be connected only to cables with copper or copper-alloy conductors. Vehicle inlet and vehicle connector to this standard are intended to be used for charging in modes 1, 2 and 3, cases B and C. The socket-outlets and plugs covered by this standard are intended to be used for charging mode 3 only, case A and B. The modes and permissible connections are specified in IEC 62196-1:2014.

Details

ICS-code 29.120.30
43.120
Dutch title Contactstoppen, contactdozen, voertuigcontactstoppen en voertuigcontactdozen - Het via een leiding opladen van elektrische voertuigen - Deel 2: Eisen aan afmetingen voor de aansluitbaarheid en uitwisselbaarheid voor met pennen en bussen uitgeruste aansluitmiddelen voor gebruik met wisselspanning
English title Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 2: Dimensional compatibility and interchangeability requirements for a.c. pin and contact-tube accessories
Replaces

Shopping Basket

Subtotal:

Go to shopping basket