Norm

ASTM A1016/A1016M - 14e1 en

Standard Specification for General Requirements for Ferritic Alloy Steel, Austenitic Alloy Steel, and Stainless Steel Tubes

  • Deze norm is ingetrokken sinds 15-03-2017

57,20 69,21 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 12
Gepubliceerd op 01-03-2014
Taal Engels

1.1 This specification covers a group of requirements that, unless otherwise specified in an individual specification, shall apply to the ASTM product specifications noted below.

Title of Specification

ASTM
DesignationA

 

 

Seamless Carbon-Molybdenum Alloy-Steel Boiler and
 Superheater Tubes

A209/A209M

Seamless Ferritic and Austenitic Alloy-Steel Boiler, Superheater,
 and Heat-Exchanger Tubes

A213/A213M

Welded Austenitic Steel Boiler, Superheater, Heat-Exchanger,
 and Condenser Tubes

A249/A249M

Electric-Resistance-Welded Ferritic Alloy-Steel Boiler and
 Superheater Tubes

A250/A250M

Seamless and Welded Ferritic and Martensitic Stainless Steel
 Tubing for General Service

A268/A268M

Seamless and Welded Austenitic Stainless Steel Tubing for
 General Service

A269

Seamless and Welded Austenitic Stainless Steel Sanitary Tubing

A270

Seamless and Welded Carbon and Alloy-Steel Tubes for
 Low-Temperature Service

A334/A334M

Welded Austenitic Stainless Steel Feedwater Heater Tubes

A688/A688M

Austenitic Stainless Steel Tubing for Breeder Reactor Core
 Components

A771/A771M

Seamless and Welded Ferritic/Austenitic Stainless Steel Tubing
 for General Service

A789/A789M

Welded Ferritic Stainless Steel Feedwater Heater Tubes

A803/A803M

Austenitic and Ferritic Stainless Steel Duct Tubes for Breeder
 Reactor Core Components

A826/A826M

High-Frequency Induction Welded, Unannealed Austenitic Steel
 Condenser Tubes

A851

(A) These designations refer to the latest issue of the respective specifications.

1.2 In the case of conflict between a requirement of a product specification and a requirement of this general requirements specification, the product specification shall prevail. In the case of conflict between a requirement of the product specification or a requirement of this general requirements specification and a more stringent requirement of the purchase order, the purchase order shall prevail.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. The inch-pound units shall apply unless the “M” designation (SI) of the product specification is specified in the order.

Details

ICS-code 77.140.20
Engelse titel Standard Specification for General Requirements for Ferritic Alloy Steel, Austenitic Alloy Steel, and Stainless Steel Tubes
Vervangt
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen