Norm

ASTM A1025/A1025M-10(2015)

Standard Specification for Ferroalloys and Other Alloying Materials, General Requirements

48,24

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie A01.18
Gepubliceerd op 01-11-2015
Taal Engels

1.1 This specification covers a group of common requirements that, unless otherwise specified in an individual specification, shall apply to ferroalloys and other alloying materials under each of the following ASTM specifications:

Title of Specification

ASTM Designation

Ferromanganese

A99

Ferrosilicon

A100

Ferrochromium

A101

Ferrovanadium

A102

Ferromolybdenum

A132

Molybdenum Oxide Products

A146

Ferroboron

A323

Ferrotitanium

A324

Chromium Metal

A481

Ferrochrome-Silicon

A482

Silicomanganese

A483

Calcium-Silicon Alloys

A495

Ferrocolumbium

A550

Electrolytic Manganese Metal

A601

Nickel Oxide Sinter

A636

Ferromanganese Silicon

A701

Titanium Scrap for Use in Deoxidation and Alloying of Steel

A845

Aluminum Scrap for Use in Deoxidation and Alloying of Steel

A846

Silicon Metal

A922

1.2 This specification also covers a group of supplementary requirements which may be applied to the above specifications as indicated therein. These are provided for use when additional testing or inspection is desired and apply only when specified individually by the purchaser in the order.

1.3 In case of conflict between the requirements of the individual specification and this general specification, the former shall prevail.

1.4 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4.1 This specification is expressed in both inch-pound units and in SI units (Within the text, the SI units are shown in brackets); however, unless the purchase order or contract specifies the applicable M specification designation (SI units), the inch-pound units shall apply.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.

Details

ICS-code 77.100
Nederlandse titel Standard Specification for Ferroalloys and Other Alloying Materials, General Requirements
Engelse titel Standard Specification for Ferroalloys and Other Alloying Materials, General Requirements

Winkelwagen

Subtotaal:

Ga naar winkelwagen