Norm

ASTM A1034/A1034M-10a(2015)

Standard Test Methods for Testing Mechanical Splices for Steel Reinforcing Bars

54,27

Over deze norm

Status Definitief
Aantal pagina's 5
Commissie A01.05
Gepubliceerd op 01-12-2015
Taal Engels

1.1 These test methods cover the testing of mechanical splices for reinforcing bars. The various tests herein described can be specified in total or individually.

1.2 The test methods herein described are applicable to any type of mechanical splice manufactured to join steel reinforcing bars of any grade (specified minimum yield strength), uncoated or coated.

1.3 This standard describes only the methods for testing mechanical splices for steel reinforcing bars, but does not quantify the parameters for testing nor acceptance criteria, which must be specified.

Note 1: Various code-writing bodies specify various parameters, such as test loads, number of cycles and test temperature, for testing.

1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 77.140.50
Nederlandse titel Standard Test Methods for Testing Mechanical Splices for Steel Reinforcing Bars
Engelse titel Standard Test Methods for Testing Mechanical Splices for Steel Reinforcing Bars

Winkelwagen

Subtotaal:

Ga naar winkelwagen