Norm

ASTM A1039/A1039M-13

Standard Specification for Steel, Sheet, Hot Rolled, Carbon, Commercial, Structural, and High-Strength Low-Alloy, Produced by Twin-Roll Casting Process

54,27

Over deze norm

Status Definitief
Aantal pagina's 9
Commissie A01.19
Gepubliceerd op 01-02-2013
Taal Engels

1.1 This specification covers commercial and structural steel sheet in coils and cut lengths produced by the twin-roll casting process.

1.2 The steel sheet is available in the designations listed in Section 4.

1.3 The material is available in the following sizes:

Thickness—0.027 in. [0.7 mm] to 0.078 in. [2.0 mm]

Width—up to 79 in. [2000 mm]


1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

Note 1A description of the Twin-Roll Casting Process is included in Appendix X1.

Details

ICS-code 77.140.01
Nederlandse titel Standard Specification for Steel, Sheet, Hot Rolled, Carbon, Commercial, Structural, and High-Strength Low-Alloy, Produced by Twin-Roll Casting Process
Engelse titel Standard Specification for Steel, Sheet, Hot Rolled, Carbon, Commercial, Structural, and High-Strength Low-Alloy, Produced by Twin-Roll Casting Process

Winkelwagen

Subtotaal:

Ga naar winkelwagen