Norm

ASTM A1053/A1053M-12e1

Standard Specification for Welded Ferritic-Martensitic Stainless Steel Pipe

48,24

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie A01.10
Gepubliceerd op 01-09-2012
Taal Engels

1.1 This specification covers seam welded ferritic-martensitic (dual phase) stainless steel pipe intended for abrasive and general corrosion service, manufactured with or without the addition of filler metal. Nominal sizes are NPS 2 to NPS 36 inclusive, with nominal (average) wall thickness up to 0.75-in. (19 mm).

1.2 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents. Therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. The inch-pound units shall apply unless the “M” designation is specified in the order.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 23.040.10
Nederlandse titel Standard Specification for Welded Ferritic-Martensitic Stainless Steel Pipe
Engelse titel Standard Specification for Welded Ferritic-Martensitic Stainless Steel Pipe

Winkelwagen

Subtotaal:

Ga naar winkelwagen