Norm

ASTM A1058 - 12 en

Standard Test Methods for Mechanical Testing of Steel Products—Metric

  • Deze norm is ingetrokken sinds 01-10-2012

57,20 69,21 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 11
Gepubliceerd op 15-03-2012
Taal Engels

1.1 These test methods cover mechanical tests described in ASTM, EN, ISO, and JIS standards that utilize the SI system of units. The test methods in each system are not exact equivalents. Each standards system (ASTM, EN, ISO, and JIS) shall be used independently of the other. Combining requirements from any two or more systems may result in nonconformance with the purchase order.

1.2 These test methods cover procedures for the mechanical testing of steels, stainless steels, and related alloys. The various mechanical tests herein described are used to determine properties required in the product specifications. Variations in testing methods are to be avoided, and standard methods of testing are to be followed to obtain reproducible and comparable results. In those cases in which the testing requirements for certain products are unique or at variance with these general procedures, the product specification testing requirements shall control.

1.3 Only one of the testing procedure tracks shall be followed: ASTM, EN, ISO, or JIS. When a test method or practice is not available in one of the tracks then an appropriate test method or practice from an alternative track shall be used. The respective tests are listed in the column shown in Table 1.

Note 1—The test methods in each system are not exact equivalents.

1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.5 Attention is directed to Practice ISO 17025 when there may be a need for information on criteria for evaluation of testing laboratories.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

TABLE 1 Tests and Applicable Standards

TestSectionsASTMENISOJIS
Tension5 to 12E8/E8M10002-16892Z 2241
Bend13E1907438A7438Z 2248
E290
Bend (tube)13102328491
Hardness14
Brinell15E106506-1A6506-1Z 2243
Rockwell16E186508-1A6508-1Z 2245
Portable17A833
E110
A1038
Impact18 to 26E2310045-1148-1Z 2242
Keywords27

A These standards are designated EN ISO; this identifies the adoption of ISO standards by EN. EN ISO is part of the designation.

Details

ICS-code 77.040.10
Engelse titel Standard Test Methods for Mechanical Testing of Steel Products—Metric
Vervangt
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen