Norm

ASTM A108 - 18 en

Standard Specification for Steel Bar, Carbon and Alloy, Cold-Finished

57,09 62,23 Incl BTW

Over deze norm

Status Definitief
Aantal pagina's 7
Gepubliceerd op 01-11-2018
Taal Engels

1.1 This specification covers cold-finished carbon and alloy steel bars produced in straight length and coil. Cold-finished bars are suitable for heat treatment, for machining into components, or for use in the as-finished condition as shafting, or in constructional applications, or for other similar purposes (Note 1). Grades of steel are identified by grade numbers or by chemical composition.

Note 1: A guide for the selection of steel bars is contained in Practice A400.

1.2 Some end uses may require one or more of the available designations shown under Supplementary Requirements. Supplementary requirements shall apply only when specified individually by the purchaser.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Details

ICS-code 77.140.60
Nederlandse titel Standard Specification for Steel Bar, Carbon and Alloy, Cold-Finished
Engelse titel Standard Specification for Steel Bar, Carbon and Alloy, Cold-Finished
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen