Norm

ASTM A203/A203M-12

Standard Specification for Pressure Vessel Plates, Alloy Steel, Nickel

48,24

Over deze norm

Status Definitief
Aantal pagina's 3
Commissie A01.11
Gepubliceerd op 01-05-2012
Taal Engels

1.1 This specification covers nickel-alloy steel plates intended primarily for welded pressure vessels.

1.2 Plates under this specification are available with four strength levels and two nickel compositions as follows:

GradeNominal Nickel
Content %
Yield Strength, min, ksi [MPa]Tensile Strength, min, ksi [MPa]
A2.2537 [255]65 [450]
B2.2540 [275]70 [485]
D3.5037 [255]65 [450]
E3.5040 [275]70 [485]
F3.50
2 in. [50 mm] and under 55 [380] 80 [550] cccc
Over 2 in. [50 mm] 50 [345] 75 [515]

1.3 The maximum thickness of plates is limited only by the capacity of the composition to meet the specified mechanical property requirements. However, current practice normally limits the maximum thickness of plates furnished under this specification as follows:

Grade Maximum Thickness, in. [mm]
A6 [150]
B6 [150]
D4 [100]
E4 [100]
F4 [100]

1.4 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents. Therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with this specification.

Details

ICS-code 77.140.30
77.140.50
Nederlandse titel Standard Specification for Pressure Vessel Plates, Alloy Steel, Nickel
Engelse titel Standard Specification for Pressure Vessel Plates, Alloy Steel, Nickel

Winkelwagen

Subtotaal:

Ga naar winkelwagen