Norm

ASTM A309 - 01(2007) en

Standard Test Method for Weight and Composition of Coating on Terne Sheet by the Triple-Spot Test

  • Deze norm is ingetrokken sinds 01-09-2012

50,60 61,23 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 6
Gepubliceerd op 01-05-2007
Taal Engels

1.1 This test method covers the determination of the weight and composition of coating on terne sheet by the triple-spot method. The following three procedures are described:

1.1.1 Procedure A - Stripping with sulfuric acid.

1.1.2 Procedure D - Stripping with hydrochloric acid and antimony trichloride.

1.1.3 Procedure E - Stripping with hydrobromic acid-bromine solution.

Procedure B (Electrolytic Stripping) and Procedure C (Stripping with Silver Nitrate Solution), formerly in this test method, were discontinued because lack of usage. The designation for Procedure D and Procedure E are retained to avoid future confusion when reference is made only to the procedure designation.

1.2 If the percent of tin in the coating is required, stripping with hydrobromic acid-bromine is the preferred procedure. Steel with a predeposited electrolytic nickel coating requires a two-stage stripping method to determine total tin content. If both the tin and lead percentage are required, stripping with sulfuric acid is recommended, but caution is advised since the sulfuric acid procedure has been found to produce high tin results (see Section 11).

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazards statements, see Section 5, Note 2, and Section 17.

Details

ICS-code 77.140.50
Engelse titel Standard Test Method for Weight and Composition of Coating on Terne Sheet by the Triple-Spot Test
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen