ASTM A367 - 11 en

Standard Test Methods of Chill Testing of Cast Iron

  • Deze norm is ingetrokken sinds 01-10-2017

50,24 54,76 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 4
Gepubliceerd op 01-07-2011
Taal Engels

1.1 These test methods of chill testing apply to gray irons that are to be free of chill in the casting and to chilled irons that are to have a specific depth of chill in the casting. Two test methods of determining the chilling tendencies of cast iron are covered as follows. For many applications either test method will be satisfactory if test pieces of the proper dimensions are selected.

1.1.1 Test Method A, Wedge TestThis test is generally better adapted to the higher strength gray irons. The accelerated cooling rate to induce the formation of a chill is brought about through the design of the test specimen. This test method is simpler than Test Method B since maintenance of chill blocks or plates is not necessary.

1.1.2 Test Method B, Chill TestThis test is better adapted to the softer grades of gray iron and should be used if the casting is to have a specified depth of chill. The chill in this type of test is induced by casting one edge of the test specimen against a metal or graphite chilled plate or block.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.2.1 The metric equivalency charts in Figs. 1 and 2 are provided for information only.


Engelse titel Standard Test Methods of Chill Testing of Cast Iron
Vervangen door



Ga naar winkelwagen