Norm

ASTM A428/A428M - 10 en

Standard Test Method for Weight [Mass] of Coating on Aluminum-Coated Iron or Steel Articles

  • Deze norm is ingetrokken sinds 01-08-2014

50,60 61,23 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 5
Gepubliceerd op 01-05-2010
Taal Engels

1.1 This test method covers procedures for determining the weight [mass] of coating on aluminum-coated iron or steel sheets and wire, and on other aluminum-coated iron and steel articles.

1.2 The final results determined by this test method shall be expressed in inch-pound units or SI units, depending on the units used in the material specification to which the results are to be compared. Certain portions of the procedure involving determination of specimen weight [mass] have traditionally been performed in SI units, and corresponding inch-pound units are not included.

1.3 For sheet products, the final results are expressed as either coating weight [mass] total both sides, or coating weight [mass] separately on each side, depending on the specified requirements.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific precautionary statement, see Note 1.

Details

ICS-code 25.220.40
Engelse titel Standard Test Method for Weight [Mass] of Coating on Aluminum-Coated Iron or Steel Articles
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen