ASTM A48/A48M-03(2012)

Standard Specification for Gray Iron Castings


Over deze norm

Status Definitief
Aantal pagina's 6
Commissie A04.01
Gepubliceerd op 01-10-2012
Taal Engels

1.1 This specification covers gray iron castings intended for general engineering use where tensile strength is a major consideration. Castings are classified on the basis of the tensile strength of the iron in separately cast test bars.

1.1.1 This specification subordinates chemical composition to tensile strength.

1.2 Castings produced to this specification are graded on the basis of minimum tensile strength obtained in special test coupons designed to standardize cooling rate. The tensile strength developed in certain casting sections may vary from test coupon values (see X1.2).

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.


ICS-code 77.140.80
Nederlandse titel Standard Specification for Gray Iron Castings
Engelse titel Standard Specification for Gray Iron Castings



Ga naar winkelwagen