Norm

ASTM A511/A511M - 15a en

Standard Specification for Seamless Stainless Steel Mechanical Tubing

  • Deze norm is ingetrokken sinds 01-05-2016

57,20 69,21 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 12
Gepubliceerd op 01-05-2015
Taal Engels

1.1 This specification covers seamless stainless tubing for use in mechanical applications where corrosion-resistant or high-temperature strength is needed. The grades covered are listed in Table 1, Table 2, and Table 3.

(A) For small diameter or thin wall tubing or both, where many drawing passes are required, a maximum of 0.040 % carbon is necessary in grades MT-304L and MT-316L. Small outside diameter tubes are defined as those under a 0.500 in. [12.7 mm] outside diameter and light-wall tubes as those under a 0.049 in. [1.2 mm] average wall thickness (0.044 in. [1.1 mm] min wall thickness).
(B) Iron shall be determined arithmetically by difference of 100 minus the sum of the other specified elements.
(C) The range of (Al + Ti) shall be within 0.85–1.20 %.
(A) MT446-2 is a lower carbon version of MT446-1, that has a lower tensile strength but improved ductility and toughness.
(B) Carbon plus nitrogen = 0.025 max %.
(A) Maximum, unless a range or minimum is indicated. Where ellipses (…) appear in this table, there is no requirement and analysis for the element need not be determined or reported.
(B) % Cr + 3.3 X % Mo + 16X % N 40.

1.2 This specification covers seamless cold-finished mechanical tubing and seamless hot-finished mechanical tubing in sizes up to 123/4 in. [325 mm] in outside nominal diameter (for round tubing) with wall thicknesses as required.

1.3 Tubes shall be furnished in one of the following shapes, as specified by the purchaser: round, square, rectangular, or special.

1.4 Optional supplementary requirements are provided and when desired, shall be stated in the order.

1.5 The values stated in inch-pound units are to be regarded as the standard. Within the text, the SI units are shown in square brackets. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other.

Details

ICS-code 23.040.10
Engelse titel Standard Specification for Seamless Stainless Steel Mechanical Tubing
Vervangt
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen