Over deze norm
1.1 This specification covers electric-resistance-welded carbon and alloy steel tubing for use as mechanical tubing.
1.2 This specification covers mechanical tubing made from hot- or cold-rolled steel.
1.3 This specification covers round, square, rectangular, and special shape tubing.
|Size Range |
|Electric-Resistance-Welded Tubing from Hot-Rolled Steel||outside diameter from 1/2 to 15 in.|
[10 to 380 mm]
| wall from 0.065 to 0.650 in.|
[1.65 to 16.50 mm]
|Electric-Resistance-Welded Tubing from Cold-Rolled Steel||outside diameter from 3/8to 12 in.|
[9.5 to 305 mm]
| wall from 0.022 to 0.134 in.|
[0.56 to 3.40 mm]
1.4 Optional supplementary requirements are provided and when desired, shall be so stated in the order.
1.5 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text the SI units are shown in brackets or parenthesis. The values stated in each system may not be exact equivalents; therefore each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. The inch-pound unts shall apply unless the “M” designation of this specification is specified in the order. In this specification hard or rationalized conversions apply to diameters, lengths and tensile properties. Soft conversion applies to other SI measurements.
|Engelse titel||Standard Specification for Electric-Resistance-Welded Carbon and Alloy Steel Mechanical Tubing|