Norm

ASTM A556/A556M-96(2012)

Standard Specification for Seamless Cold-Drawn Carbon Steel Feedwater Heater Tubes

54,27

Over deze norm

Status Definitief
Aantal pagina's 5
Commissie A01.09
Gepubliceerd op 01-03-2012
Taal Engels

1.1 This specification2 covers minimum-wall-thickness, seamless cold-drawn carbon steel tubes including bending into the form of U-tubes, if specified, for use in tubular feedwater heaters.

1.2 The tubing sizes covered shall be 5/8 to 11/4-in. [15.9 to 31.8-mm] outside diameter, inclusive, with minimum wall thicknesses equal to or greater than 0.045 in. [1.1 mm].

1.3 Optional supplementary requirements are provided, and when desired, shall be stated in the order.

1.4 The values stated in either inch-pound units or SI units are to be regarded separately as the standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. The inch-pound units shall apply unless the ???M??? designation of this specification is specified in the order.

Details

ICS-code 23.040.10
Nederlandse titel Standard Specification for Seamless Cold-Drawn Carbon Steel Feedwater Heater Tubes
Engelse titel Standard Specification for Seamless Cold-Drawn Carbon Steel Feedwater Heater Tubes

Winkelwagen

Subtotaal:

Ga naar winkelwagen