Norm

ASTM A565/A565M - 10 en

Standard Specification for Martensitic Stainless Steel Bars for High-Temperature Service

  • Deze norm is ingetrokken sinds 15-03-2017

45,11 54,58 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 4
Gepubliceerd op 01-10-2010
Taal Engels

1.1 This specification covers hot-finished and cold-finished martensitic chromium steel bars for high-temperature service. The mechanical properties are developed by suitable heat treatment, as indicated for each alloy.

1.2 Where strength at temperature is a factor, these steels are generally limited to a maximum service temperature of 1200°F [650°C]. For oxidation (scaling) resistance and at low stresses, these steels are useful to 1450°F [790°C].

1.3 This specification is expressed in both inch-pound units and SI units; however, unless the purchase order or contract specifies the applicable M specification designation (SI units), the inch-pound units shall apply. The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.

Details

ICS-code 77.140.60
Engelse titel Standard Specification for Martensitic Stainless Steel Bars for High-Temperature Service
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen