Norm

ASTM A574-17

Standard Specification for Alloy Steel Socket-Head Cap Screws

50,47

Over deze norm

Status Definitief
Aantal pagina's 7
Commissie F16.02
Gepubliceerd op 01-06-2017
Taal Engels

1.1 This specification covers the requirements for quenched and tempered alloy steel hexagon socket-head cap screws, 0.060 through 4 in. in diameter where high strength is required.

1.2 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 The following hazard caveat pertains only to the test method portions, sections 5.1, 5.6, 8, and 12, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Details

ICS-code 21.060.10
Nederlandse titel Standard Specification for Alloy Steel Socket-Head Cap Screws
Engelse titel Standard Specification for Alloy Steel Socket-Head Cap Screws

Winkelwagen

Subtotaal:

Ga naar winkelwagen