Norm

ASTM A579/A579M - 17 en

Standard Specification for Superstrength Alloy Steel Forgings

  • Deze norm is ingetrokken sinds 01-11-2017

50,60 61,23 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 7
Gepubliceerd op 01-02-2017
Taal Engels

1.1 This specification covers requirements for forged steel shapes for highly stressed structural members requiring yield strengths in excess of 140 ksi [965 MPa].

1.2 This specification is not intended for applications limited by creep deformation.

1.3 Twenty-eight grades are covered by this specification. Selection will depend upon design, service conditions, and mechanical properties required.

1.4 Supplementary requirements are provided for use when additional testing or inspection is desired. These shall apply only when specified individually by the purchaser in the order.

1.5 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.6 Unless the order specifies the applicable “M” specification designation, the material shall be furnished to the inch-pound units.

Details

ICS-code 77.140.85
Engelse titel Standard Specification for Superstrength Alloy Steel Forgings
Vervangt
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen