ASTM A582/A582M - 12 en

Standard Specification for Free-Machining Stainless Steel Bars

  • Deze norm is ingetrokken sinds 01-03-2012

44,68 54,06 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 4
Gepubliceerd op 01-03-2012
Taal Engels

1.1 This specification covers hot-finished or cold-finished bars, except bars for forging (Note 1), suitable for machining processes. It includes rounds, squares, and hexagons in the more commonly used types of stainless free-machining steels designed especially for optimum machinability and for general corrosion and high-temperature service. Stainless steel bars other than the free-machining types are covered in a separate specification (Note 2).

1.2 This specification is expressed in both inch-pound units and in SI units; however, unless the purchase order or contract specifies the applicable M specification designation (SI units), the inch-pound units shall apply. The values stated in either inch-pound units or SI (metric) units are to be regarded separately as standard: within the text and tables, the SI units are shown in [brackets]. The values stated in each system may not be exact equivalents: therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.

Note 1—For bars for reforging, see Specification A314.

Note 2—For non-free machining stainless bars, see Specification A276.


ICS-code 77.140.60
Engelse titel Standard Specification for Free-Machining Stainless Steel Bars
Vervangen door



Ga naar winkelwagen