Norm

ASTM A626/A626M-13

Standard Specification for Tin Mill Products, Electrolytic Tin Plate, Double Reduced

54,27

Over deze norm

Status Definitief
Aantal pagina's 5
Commissie A01.20
Gepubliceerd op 01-10-2013
Taal Engels

1.1 This specification covers double-reduced electrolytic tin plate produced from low-carbon cold-reduced steel furnished in coils and cut sizes for use predominately in the manufacture of cans. It is furnished in commercially available tin coating weights [masses] and is normally supplied with a trimmed edge.

1.2 This specification is applicable to orders in either inch-pound units (as A626) which is supplied in thicknesses from 0.0050 to 0.0118 in. or SI units [as A626M] which is supplied in thicknesses from 0.127 to 0.300 mm.

1.3 The values stated in either inch-pound or SI units are to be regarded as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents. Therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with this specification.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 77.140.50
Nederlandse titel Standard Specification for Tin Mill Products, Electrolytic Tin Plate, Double Reduced
Engelse titel Standard Specification for Tin Mill Products, Electrolytic Tin Plate, Double Reduced

Winkelwagen

Subtotaal:

Ga naar winkelwagen