Norm

ASTM A675/A675M-14

Standard Specification for Steel Bars, Carbon, Hot-Wrought, Special Quality, Mechanical Properties

48,24

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie A01.15
Gepubliceerd op 01-05-2014
Taal Engels

1.1 This specification2 covers hot-wrought special quality carbon steel bars and bar size shapes produced to mechanical property requirements and intended for general constructional applications.

1.2 The bars are available in nine strength grades designated 45, 50, 55, 60, 65, 70, 75, 80, and 90 [310, 345, 380, 415, 450, 485, 515, 550, and 620] corresponding to the minimum ultimate tensile strength in ksi [MPa]. The chemical composition is selected by the manufacturer to develop the required mechanical properties.

1.3 Hot-wrought special quality carbon steel bars subject to mechanical property requirements are hot wrought in straight lengths only. Sections and sizes available are covered in Specification A29/A29M.

1.4 Some applications may require one or more of the available designations shown under Supplementary Requirements.

Note 1Merchant-quality hot-wrought carbon steel bars subject to mechanical property requirements are covered in Specification A663/A663M.

1.5 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

Details

ICS-code 77.140.60
Nederlandse titel Standard Specification for Steel Bars, Carbon, Hot-Wrought, Special Quality, Mechanical Properties
Engelse titel Standard Specification for Steel Bars, Carbon, Hot-Wrought, Special Quality, Mechanical Properties

Winkelwagen

Subtotaal:

Ga naar winkelwagen