Norm

ASTM A704/A704M-17

Standard Specification for Welded Steel Plain Bar or Rod Mats for Concrete Reinforcement

44,31

Over deze norm

Status Definitief
Aantal pagina's 3
Commissie A01.05
Gepubliceerd op 01-09-2017
Taal Engels

1.1 This specification covers material in mat (or sheet) form fabricated from hot-rolled, plain steel bars or rods to be used for the reinforcement of concrete. Mats consist of two layers of bars or rods which are assembled by welding at right angles to each other.

1.2 This specification is applicable for orders in either inch-pound units (as A704) or in SI units [as A704M].

1.3 The values stated in either inch-pound units or SI units are to be regarded as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with this specification.

1.4 This specification does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this specification to establish appropriate safety, health and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Details

ICS-code 77.140.15
Nederlandse titel Standard Specification for Welded Steel Plain Bar or Rod Mats for Concrete Reinforcement
Engelse titel Standard Specification for Welded Steel Plain Bar or Rod Mats for Concrete Reinforcement

Winkelwagen

Subtotaal:

Ga naar winkelwagen