Norm

ASTM A717/A717M-12

Standard Test Method for Surface Insulation Resistivity of Single-Strip Specimens

48,24

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie A06.01
Gepubliceerd op 01-05-2012
Taal Engels

1.1 This test method covers a means of testing the surface insulation resistivity of single strips or punchings of flat-rolled electrical steel under predetermined conditions of voltage, pressure, and temperature.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 29.035.20
Nederlandse titel Standard Test Method for Surface Insulation Resistivity of Single-Strip Specimens
Engelse titel Standard Test Method for Surface Insulation Resistivity of Single-Strip Specimens

Winkelwagen

Subtotaal:

Ga naar winkelwagen