Norm

ASTM A720/A720M-02(2016)e1

Standard Test Method for Ductility of Nonoriented Electrical Steel

48,24

Over deze norm

Status Definitief
Aantal pagina's 2
Commissie A06.01
Gepubliceerd op 01-04-2016
Taal Engels

1.1 This test method covers determination of ductility utilizing Epstein test strips and a bending device for bending the strip over a predetermined radius. It is intended for commercial silicon-bearing steel sheet or strip of nonoriented types in the thickness range from 0.010 to 0.031 in. [0.25 to 0.79 mm], inclusive.

1.2 The values and equations stated in customary (cgs-emu and inch-pound) or SI units are to be regarded separately as standard. Within this test method, SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with this test method.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 77.140.50
Nederlandse titel Standard Test Method for Ductility of Nonoriented Electrical Steel
Engelse titel Standard Test Method for Ductility of Nonoriented Electrical Steel

Winkelwagen

Subtotaal:

Ga naar winkelwagen