Norm

ASTM A767/A767M-16

Standard Specification for Zinc-Coated (Galvanized) Steel Bars for Concrete Reinforcement

54,27

Over deze norm

Status Definitief
Aantal pagina's 5
Commissie A01.05
Gepubliceerd op 01-09-2016
Taal Engels

1.1 This specification covers steel reinforcing bars with protective zinc coatings applied by immersing the properly prepared reinforcing bars into a molten bath of zinc.

Note 1: The galvanizer is identified throughout this specification as the manufacturer.

1.2 Guidelines for construction practices at the job-site are presented in Appendix X1.

1.3 Guidelines for use of zinc-coated (galvanized) reinforcing bars with non-galvanized steel forms are presented in Appendix X2.

1.4 The text of this specification references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables) shall not be considered as requirements of the specification.

1.5 This specification is applicable for orders in either inch-pound units (as Specification A767) or SI units (as Specification A767M).

1.6 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents. Therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with this specification.

Details

ICS-code 77.140.15
Nederlandse titel Standard Specification for Zinc-Coated (Galvanized) Steel Bars for Concrete Reinforcement
Engelse titel Standard Specification for Zinc-Coated (Galvanized) Steel Bars for Concrete Reinforcement

Winkelwagen

Subtotaal:

Ga naar winkelwagen