Norm

ASTM A833-08a(2014)

Standard Practice for Indentation Hardness of Metallic Materials by Comparison Hardness Testers

48,24

Over deze norm

Status Definitief
Aantal pagina's 3
Commissie A01.06
Gepubliceerd op 01-10-2014
Taal Engels

1.1 This practice covers the determination of indentation hardness of metallic materials using comparison hardness testers.

1.2 This practice applies only to those comparison hardness testers, normally portable, that use comparative test bars that have been standardized according to Test Method E10 as a basis for comparison.

1.3 Calibration of comparative test bars (rods), used for comparison to determine hardness numbers, is also covered by this practice.

1.4 The impression force used during comparison hardness testing is normally an impact load applied by striking a hammer on the appropriate areas as outlined in the manufacturer's instructions.

1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.6 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 77.040.10
Nederlandse titel Standard Practice for Indentation Hardness of Metallic Materials by Comparison Hardness Testers
Engelse titel Standard Practice for Indentation Hardness of Metallic Materials by Comparison Hardness Testers

Winkelwagen

Subtotaal:

Ga naar winkelwagen