Over deze norm
1.1 This specification covers deformed and plain steel reinforcing bars which prior to surface preparation are prefabricated and then coated with a protective fusion-bonded epoxy coating by electrostatic spray or other suitable method.
1.2 Prefabricated steel reinforcing bars coated with fusion-bonded epoxy powder coating in accordance with this specification are intended to be fabricated before being coated.
1.3 Organic coatings other than epoxy may be used provided they meet the requirements of this specification.
1.4 Requirements for epoxy coatings are contained in .
1.5 Guidelines for application process and product test procedures of epoxy coatings for steel reinforcing bars are presented in .
1.6 Guidelines for construction practices at the job-site for coated steel reinforcing bars are presented in .
1.7 This specification is applicable for orders in either SI (metric) units (as Specification ) or inch-pound units [as Specification ].
1.8 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.9 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
|Nederlandse titel||Standard Specification for Epoxy-Coated Prefabricated Steel Reinforcing Bars|
|Engelse titel||Standard Specification for Epoxy-Coated Prefabricated Steel Reinforcing Bars|