ASTM A960/A960M - 19 en

Standard Specification for Common Requirements for Wrought Steel Piping Fittings

  • Deze norm is ingetrokken sinds 01-11-2019

57,09 62,23 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 10
Gepubliceerd op 01-03-2019
Taal Engels

1.1 This specification covers a group of common requirements that shall apply to wrought steel piping fittings covered in any of the following individual product specifications or any other ASTM specification that invokes this specification or portions thereof:

Title of Specification


Specification for Piping Fittings of Wrought
  Carbon Steel and Alloy Steel for Moderate and
  High Temperature Service


Specification for Wrought Austenitic Stainless
  Steel Piping Fittings


Specification for Piping Fittings of Wrought Carbon
  Steel and Alloy Steel for Low-Temperature Service


Specification for Wrought-Carbon Steel Butt-Welding
  Piping Fittings with Improved Notch Toughness


Specification for As-Welded Wrought Austenitic
  Stainless Steel Fittings for General Corrosive
  Service at Low and Moderate Temperatures


Specification for Wrought Ferritic, Ferritic/Austenitic,
  and Martensitic Stainless Steel Piping Fittings


Specification for Heat-Treated Carbon Steel
  Fittings for Low-Temperature and Corrosive Service


Specification for Wrought High-Strength
  Ferritic Steel Butt-Welding Fittings


1.2 In case of conflict between a requirement of the individual product specification and a requirement of this general requirement specification, the requirements of the individual product specification shall prevail over those of this specification.

1.3 By mutual agreement between the purchaser and the supplier, additional requirements may be specified (See 4.1.8). The acceptance of any such additional requirements shall be dependent on negotiations with the supplier and must be included in the order as agreed upon by the purchaser and supplier.

1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text and the tables, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the specification. The inch-pound units shall apply unless the “M” designation [SI] of the product specification is specified in the order.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


ICS-code 23.040.40
Nederlandse titel Standard Specification for Common Requirements for Wrought Steel Piping Fittings
Engelse titel Standard Specification for Common Requirements for Wrought Steel Piping Fittings
Vervangen door



Ga naar winkelwagen