Norm

ASTM A960/A960M-16

Standard Specification for Common Requirements for Wrought Steel Piping Fittings

49,88

Over deze norm

Status Definitief
Aantal pagina's 10
Commissie A01.22
Gepubliceerd op 01-06-2016
Taal Engels

1.1 This specification covers a group of common requirements that shall apply to wrought steel piping fittings covered in any of the following individual product specifications or any other ASTM specification that invokes this specification or portions thereof:

Title of Specification

ASTM
Designation

Specification for Piping Fittings of Wrought
  Carbon Steel and Alloy Steel for Moderate and
  Elevated Temperatures

A234/A234M

Specification for Wrought Austenitic Stainless
  Steel Piping Fittings

A403/A403M

Specification for Piping Fittings of Wrought Carbon
  Steel and Alloy Steel for Low-Temperature Service

A420/A420M

Specification for Butt-Welding, Wrought-Carbon
  Steel, Piping Fittings with Improved Notch Toughness

A758/A758M

Specification for As-Welded Wrought Austenitic
  Stainless Steel Fittings for General Corrosive
  Service at Low and Moderate Temperatures

A774/A774M

Specification for Wrought Ferritic, Ferritic/Austenitic,
  and Martensitic Stainless Steel Piping Fittings

A815/A815M

Specification for Heat-Treated Carbon Steel
  Fittings for Low-Temperature and Corrosive Service

A858/A858M

Specification for Wrought High-Strength
  Low-Alloy Steel Butt-Welded Fittings

A860/A860M

1.2 In case of conflict between a requirement of the individual product specification and a requirement of this general requirement specification, the requirements of the individual product specification shall prevail over those of this specification.

1.3 By mutual agreement between the purchaser and the supplier, additional requirements may be specified (See 4.1.8). The acceptance of any such additional requirements shall be dependent on negotiations with the supplier and must be included in the order as agreed upon by the purchaser and supplier.

1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text and the tables, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the specification. The inch-pound units shall apply unless the “M” designation [SI] of the product specification is specified in the order.

Details

ICS-code 23.040.40
77.140.20
Nederlandse titel Standard Specification for Common Requirements for Wrought Steel Piping Fittings
Engelse titel Standard Specification for Common Requirements for Wrought Steel Piping Fittings

Winkelwagen

Subtotaal:

Ga naar winkelwagen