ASTM A961/A961M - 19 en

Standard Specification for Common Requirements for Steel Flanges, Forged Fittings, Valves, and Parts for Piping Applications

  • Deze norm is ingetrokken sinds 01-11-2019

57,09 62,23 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 9
Gepubliceerd op 01-03-2019
Taal Engels

1.1 This specification covers a group of common requirements that shall apply to steel flanges, forged fittings, valves, and parts for piping applications under any of the following individual product specifications:

Title of Specification

ASTM Designation



Forgings, Carbon Steel, for Piping Components


Forgings, Carbon Steel, for General-Purpose Piping


Forged or Rolled Alloy-Steel Pipe Flanges, Forged


  Fittings, and Valves and Parts for High Temperature


Forgings, Carbon and Low Alloy Steel, Requiring Notch


  Toughness Testing for Piping Components


Forged or Rolled 8 and 9 % Nickel Alloy


  Steel Flanges, Fittings, Valves, and Parts


  for Low-Temperature Service


Forgings, Carbon and Alloy Steel, for Pipe Flanges,


  Fittings, Valves, and Parts for High-Pressure
  Transmission Service


Flanges, Forged, Carbon and Alloy Steel for Low


  Temperature Service


Forgings, Carbon Steel, for Piping Components with


  Inherent Notch Toughness


Forgings, Titanium-Stabilized Carbon Steel, for


  Glass-Lined Piping and Pressure Vessel Service


1.2 In case of conflict between a requirement of the individual product specification and a requirement of this general requirement specification, the requirements of the individual product specification shall prevail over those of this specification.

1.3 By mutual agreement between the purchaser and the supplier, additional requirements may be specified (see Section 4.1.2). The acceptance of any such additional requirements shall be dependent on negotiations with the supplier and must be included in the order as agreed upon between the purchaser and supplier.

1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text and the tables, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. The inch-pound units shall apply, unless the “M” designation (SI) of the product specification is specified in the order.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


ICS-code 23.040.01
Engelse titel Standard Specification for Common Requirements for Steel Flanges, Forged Fittings, Valves, and Parts for Piping Applications
Vervangen door



Ga naar winkelwagen