Norm

ASTM A971/A971M-10

Standard Test Method for Measuring Edge Taper and Crown of Flat-Rolled Electrical Steel Coils

48,24

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie A06.01
Gepubliceerd op 01-11-2010
Taal Engels

1.1 This test method provides a procedure for measuring edge taper and crown of flat-rolled electrical steel coils as produced at the steel mill.

1.2 The values and equations stated in customary (cgs-emu and inch-pound) units or SI units are to be regarded separately as standard. Within this standard, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with this standard.

1.3 The following material specifications include requirements for edge taper or crown: A677, A683, A726, A840, and A876.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 77.140.50
Nederlandse titel Standard Test Method for Measuring Edge Taper and Crown of Flat-Rolled Electrical Steel Coils
Engelse titel Standard Test Method for Measuring Edge Taper and Crown of Flat-Rolled Electrical Steel Coils

Winkelwagen

Subtotaal:

Ga naar winkelwagen