Norm

ASTM A985/A985M - 11a en

Standard Specification for Steel Investment Castings General Requirements, for Pressure-Containing Parts

  • Deze norm is ingetrokken sinds 01-05-2012

57,20 69,21 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 11
Gepubliceerd op 01-10-2011
Taal Engels

1.1 This specification covers a group of common requirements that are mandatory for steel castings produced by the investment casting process for pressure-containing parts under each of the following ASTM Specifications:

Title of Specification ASTM Designation
Steel Castings, Carbon, Suitable for Fusion Welding, A216/A216M
for High-Temperature Service
Steel Castings, Martensitic Stainless and Alloy, for A217/A217M
Pressure-Containing Parts, Suitable for High-
Temperature Service
Castings, Austenitic, Austenitic-Ferritic (Duplex), A351/A351M
for Pressure-Containing Parts
Steel Castings, Ferritic and Martensitic, for Pressure- A352/A352M
Containing Parts, Suitable for Low-Temperature
Service
Steel Castings, Alloy, Specially Heat-Treated, for A389/A389M
Pressure-Containing Parts, Suitable for High-
Temperature Service
Steel Castings Suitable for Pressure Service A487/A487M

1.2 This specification also covers a group of supplementary requirements, which may be applied to the above specifications as indicated therein. These requirements are provided for use when additional testing or inspection is desired and apply only when specified individually by the purchaser in the order.

1.3 When investment casting is ordered, the requirements of this specification shall take precedence over the individual material specification requirements.

1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 49.025.10
Engelse titel Standard Specification for Steel Investment Castings General Requirements, for Pressure-Containing Parts
Vervangt
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen