ASTM A985/A985M - 20 en

Standard Specification for Steel Investment Castings General Requirements, for Pressure-Containing Parts

63,94 69,69 Incl BTW

Over deze norm

Status Definitief
Aantal pagina's 12
Gepubliceerd op 01-07-2020
Taal Engels

1.1 This specification covers a group of common requirements that are mandatory for steel castings produced by the investment casting process for pressure-containing parts under each of the following ASTM Specifications:


Title of Specification

ASTM Designation




Steel Castings, Carbon, Suitable for Fusion Welding,



for High-Temperature Service


Steel Castings, Martensitic Stainless and Alloy, for



Pressure-Containing Parts, Suitable for High-



Temperature Service


Castings, Austenitic, for Pressure-Containing





Steel Castings, Ferritic and Martensitic, for Pressure-



Containing Parts, Suitable for Low-Temperature





Steel Castings, Alloy, Specially Heat-Treated, for



Pressure-Containing Parts, Suitable for High-



Temperature Service


Steel Castings Suitable for Pressure Service


Castings, Iron-Nickel-Chromium and Nickel Alloys, Spe-
     cially Controlled for Pressure-Retaining Parts for
     Corrosive Service


Castings, Austenitic-Ferritic (Duplex) Stainless Steel, for
     Pressure-Containing Parts


1.2 This specification also covers a group of supplementary requirements, which may be applied to the above specifications as indicated therein. These requirements are provided for use when additional testing or inspection is desired, and apply only when specified individually by the purchaser in the order.

1.3 When investment casting is ordered, the requirements of this specification shall take precedence over the individual material specification requirements.

1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


ICS-code 49.025.10
Engelse titel Standard Specification for Steel Investment Castings General Requirements, for Pressure-Containing Parts



Ga naar winkelwagen