Norm

ASTM A991/A991M-10(2015)

Standard Test Method for Conducting Temperature Uniformity Surveys of Furnaces Used to Heat Treat Steel Products

48,24

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie A01.13
Gepubliceerd op 01-03-2015
Taal Engels

1.1 This test method covers the procedures used to conduct a temperature uniformity survey on a furnace used to heat treat steel products. This method is used to determine the capability of the furnace to meet the permissible temperature variation specified in the applicable product specification, or as agreed to by the purchaser and supplier of heat treat services. Survey documentation requirements, and the procedure used to subsequently establish the furnace working zone, are defined in this test method.

1.2 This test method covers heat treat furnaces in any of the following categories:

1.2.1 Continuous or semi-continuous conveyance furnaces,

1.2.2 Batch furnaces, and

1.2.3 Salt or liquid baths and fluidized beds.

1.3 This test method only applies when specified in the product specification or the purchase order.

1.4 Controlling a heat treatment of steel products using thermocouples attached to the extremities of each load is an alternative to performing a furnace survey.

1.5 By mutual agreement between the purchaser and the supplier of heat treat services, more stringent and/or additional requirements may be specified. The acceptance of any such additional requirements shall be dependent on negotiations with the supplier and must be included in the order as agreed upon by the purchaser and supplier.

1.6 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 25.200
Nederlandse titel Standard Test Method for Conducting Temperature Uniformity Surveys of Furnaces Used to Heat Treat Steel Products
Engelse titel Standard Test Method for Conducting Temperature Uniformity Surveys of Furnaces Used to Heat Treat Steel Products

Winkelwagen

Subtotaal:

Ga naar winkelwagen