Norm

ASTM B16/B16M-10(2015)

Standard Specification for Free-Cutting Brass Rod, Bar and Shapes for Use in Screw Machines

54,27

Over deze norm

Status Definitief
Aantal pagina's 5
Commissie B05.02
Gepubliceerd op 01-05-2015
Taal Engels

1.1 This specification establishes the requirements for free-cutting brass rod, bar, wire, and shapes of any specified cross section produced from Copper Alloy UNS Nos. C36000 or C36010 suitable for high-speed screw machining applications and moderate thread rolling.

1.2 Units—Values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.2.1 Within the text, SI units are shown in brackets.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 77.150.30
Nederlandse titel Standard Specification for Free-Cutting Brass Rod, Bar and Shapes for Use in Screw Machines
Engelse titel Standard Specification for Free-Cutting Brass Rod, Bar and Shapes for Use in Screw Machines

Winkelwagen

Subtotaal:

Ga naar winkelwagen