Norm

ASTM B179-14

Standard Specification for Aluminum Alloys in Ingot and Molten Forms for Castings from All Casting Processes

61,51

Over deze norm

Status Definitief
Aantal pagina's 11
Commissie B07.01
Gepubliceerd op 01-10-2014
Taal Engels

1.1 This specification covers commercial aluminum alloys in ingot form for remelting and molten form for the manufacture of castings. The specific gravity of these alloys does not exceed 3.0 and they are designated as shown in Table 1.

Note 1: Throughout this specification the use of “ingot” in a general sense includes sow, T-bar, T-ingot, and pig.

1.2 Alloy designations are in accordance with ANSI H35.1/H35.1(M). The equivalent Unified Numbering System alloy designations are in accordance with Practice E527.

Note 2: Supplementary data pertaining to the alloys covered by this specification when used in the form of castings are given in Specifications B26/B26M, B85/B85M, B108/B108M, B618/B618M, B686/B686M, and B955/B955M.

1.3 Unless the order specifies the “M” specification designation, the material shall be furnished to the inch-pound units.

1.4 For acceptance criteria for inclusion of new aluminum and aluminum alloys in this specification, see Annex A1.

1.5 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 77.150.10
Nederlandse titel Standard Specification for Aluminum Alloys in Ingot and Molten Forms for Castings from All Casting Processes
Engelse titel Standard Specification for Aluminum Alloys in Ingot and Molten Forms for Castings from All Casting Processes

Winkelwagen

Subtotaal:

Ga naar winkelwagen