Norm

ASTM B183-79(2014)

Standard Practice for Preparation of Low-Carbon Steel for Electroplating

48,24

Over deze norm

Status Definitief
Aantal pagina's 3
Commissie B08.02
Gepubliceerd op 01-11-2014
Taal Engels

1.1 This practice is intended as an aid to electroplaters in setting up a suitable cleaning cycle preparatory to electroplating of low-carbon steel (Note 1) containing less than 0.35 mass % of carbon and to indicate some of the precautions that must be taken to maintain this cycle in good operating condition.

Note 1: The preparation of high-carbon steel for electroplating is covered in Guide B242.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

Nederlandse titel Standard Practice for Preparation of Low-Carbon Steel for Electroplating
Engelse titel Standard Practice for Preparation of Low-Carbon Steel for Electroplating

Winkelwagen

Subtotaal:

Ga naar winkelwagen