Norm

ASTM B196/B196M - 18 en

Standard Specification for Copper-Beryllium Alloy Rod and Bar

50,60 61,23 Incl BTW

Over deze norm

Status Definitief
Aantal pagina's 5
Gepubliceerd op 01-03-2018
Taal Engels

1.1 This specification establishes the requirements for copper-beryllium alloy rod and bar in straight lengths. The following three alloys are included:

Copper Alloy
UNS No.

Previously Used
Designations

Nominal Beryllium
Content, %

 

 

 

C17000

Alloy 165

1.7

C17200

Alloy  25

1.9

C17300

 

1.9

 

 

+0.4 lead

1.2 Unless otherwise required, Copper Alloy UNS No. C17200 shall be the alloy furnished whenever Specification B196/B196M is specified without any alloy designation.

1.3 The values stated in either inch-pounds or SI units are to be regarded separately as the standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Details

ICS-code 77.150.30
Engelse titel Standard Specification for Copper-Beryllium Alloy Rod and Bar
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen