Norm

ASTM B197/B197M-07(2013)

Standard Specification for Copper-Beryllium Alloy Wire

54,27

Over deze norm

Status Definitief
Aantal pagina's 6
Commissie B05.02
Gepubliceerd op 01-04-2013
Taal Engels

1.1 This specification establishes the requirements for copper-beryllium alloy wire in coils, spools, or other than straight lengths, of any uniform cross section. Copper Alloy UNS Nos. C17200 and C173002 are included.

1.2 Unless otherwise required, Copper Alloy UNS No. C17200 shall be the alloy furnished whenever Specification B197/B197Mis specified without any alloy designation.

1.3 The values stated in either inch-pounds or SI units are to be regarded separately as the standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.

1.4 The following safety hazard caveat pertains only to the test methods described in this specification:

1.4.1 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 77.150.30
Nederlandse titel Standard Specification for Copper-Beryllium Alloy Wire
Engelse titel Standard Specification for Copper-Beryllium Alloy Wire

Winkelwagen

Subtotaal:

Ga naar winkelwagen