Norm

ASTM B306-13

Standard Specification for Copper Drainage Tube (DWV)

54,27

Over deze norm

Status Definitief
Aantal pagina's 6
Commissie B05.04
Gepubliceerd op 01-04-2013
Taal Engels

1.1 This specification establishes the requirements for seamless copper tube (DWV) produced from Copper UNS No. C12200 and intended for sanitary drainage, waste, and vent piping.

Note 1Fittings used for soldered or brazed connections in drainage, waste, or vent systems are described in ASME Standards B16.23 and B16.29 and CSA Standard B158.1.
Note 2The assembly of copper drainage, waste, and vent systems by soldering is described in Practice B828.
Note 3Solders for joining copper drainage, waste, or vent systems are described in Specification B32. The requirement for acceptable fluxes for these systems are described in Specification B813.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 The following hazard statement pertains only to the test method described in Section 16.2.3 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 23.040.15
Nederlandse titel Standard Specification for Copper Drainage Tube (DWV)
Engelse titel Standard Specification for Copper Drainage Tube (DWV)

Winkelwagen

Subtotaal:

Ga naar winkelwagen